(PDF) Heat Exchanger Types and Classifications

In concurrent,o r parallel-flow, units the two fluid streams enter together at one end, flow through in the same direction, and leave together at the othe r end. 2.

Learn More

List of ASTM International standards - Wikipedia

A937/A937M - 12(2019) Test Method for Determining Interlaminar Resistance of Insulating Coatings Using Two Adjacent Test Surfaces A938 - 18 Test Method for Torsion Testing of Wire A939/A939M - 15(2020) Practice for Ultrasonic Examination from Bored Surfaces of Cylindrical Forgings

Learn More

Chapter 6: Water Supply and Distribution, Plumbing Code of

A low-pressure cutoff shall be installed on all booster pumps in a water pressure booster system to prevent creation of a vacuum or negative pressure on the suction side of the pump when a positive pressure of 10 psi (68.94 kPa) or less occurs on the suction side of the pump.

Learn More

2018 INTERNATIONAL RESIDENTIAL CODE (IRC) - CHAPTER 7

Anchorage of the steel angle at every double stud spacing shall be not less than two 7 / 16-inch-diameter (11 mm) by 4-inch (102 mm) lag screws for wood construction or two 7 / 16-inch (11.1 mm) bolts with washers for cold-formed steel construction.

Learn More

Chapter 2: Definitions, 2020 Residential Code of New York

Pressure created by any means in the water distribution system that by being in excess of the pressure in the water supply mains causes a potential backflow condition. [MP] BACKPRESSURE, LOW HEAD. A pressure less than or equal to 4.33 psi (29.88 kPa) or the pressure exerted by a 10-foot (3048 mm) column of water. [MP] BACKSIPHONAGE.

Learn More

Solar thermal collector - Wikipedia

A solar thermal collector collects heat by absorbing sunlight.The term "solar collector" commonly refers to a device for solar hot water heating, but may refer to large power generating installations such as solar parabolic troughs and solar towers or non water heating devices such as solar air heaters.. Solar thermal collectors are either non-concentrating or concentrating.

Learn More

Légis Québec

However, a natural person who, to obtain a contractors licence or to qualify a partnership or legal person for a licence, has passed the examination on construction site safety management skills required by the Regulation respecting the professional qualification of contractors and owner-builders (chapter B-1.1, r. 9) or who is exempted therefrom by that regulation or by a regulation under

Learn More

Standard design for small-scale modular slaughterhouses

All piping shall, on completion of installation, be subject to a pressure test of 7 bar or 11/2 times the mains water pressure. While under pressure the pipework shall be carefully tested for leaks. Where a suitable test pump is not available pipework may be tested at normal working pressure and inspected as above. SECTION 2.9 : CHILLER

Learn More

Glossary of rail transport terms - Wikipedia

Also Centering spring cylinder. A cylindrical cast-iron holder in which an adjusting string is placed. Adjusting Spring Seat A casting, or a part of the bolster of a two-wheel trailing truck, forming a bearing for the end of the adjusting spring. Admission The opening of steam port to admit steam to one end of a cylinder. If the valve has no lead, admission takes place at the moment the piston

Learn More

Piping Layouts for Hydronic Heat | JLC Online

Two-pipe systems are the best choice for use with low-temperature heat sources such as heat pumps or condensing boilers. Radiant floor systems can be considered two-pipe systems since each floor circuit is connected in parallel with the other circuits at the manifold stations.

Learn More