Compressor - Wikipedia

A compressor is a mechanical device that increases the pressure of a gas by reducing its volume.An air compressor is a specific type of gas compressor.. Compressors are similar to pumps: both increase the pressure on a fluid and both can transport the fluid through a pipe.As gases are compressible, the compressor also reduces the volume of a gas. Liquids are relatively incompressible; while

Learn More

Surface condenser - Wikipedia

Purpose. In thermal power plants, the purpose of a surface condenser is to condense the exhaust steam from a steam turbine to obtain maximum efficiency, and also to convert the turbine exhaust steam into pure water (referred to as steam condensate) so that it may be reused in the steam generator or boiler as boiler feed water.. Why it is required. The steam turbine itself is a device to

Learn More

Learn about steam | Spirax Sarco

Find out about the principles of steam engineering and heat transfer, including a comprehensive guide to engineering best practice covering all aspects of steam and condensate systems; from the boiler house and steam distribution system up to the point of use; through the condensate recovery system and returning to the boiler. Virtually all major applications and products are discussed.

Learn More

Water Handbook - Chemical Feed Systems | SUEZ

As shown in Figure 35-17, a steam generating system includes three major components for which treatment is required: the deaerator, the boiler, and the condensate system. Oxygen scavengers are usually fed to the storage section of the deaerator. The boiler internal treatment is fed to the feedwater pump suction or discharge, or to the steam drum.

Learn More

Valve and Flow Control Specialists | Valveforce | Valve

At Valveforce, we are valve and flow control specialists, but we are also so much more than that! Our team are also highly experienced in the areas of condensate and steam systems.We understand your steam and condensate issues and can offer a variety of solutions to

Learn More

Economizer - Wikipedia

The first successful economizer design was used to increase the steam-raising efficiency of the boilers of stationary steam engines.It was patented by Edward Green in 1845, and since then has been known as Green's economiser.It consisted of an array of vertical cast iron tubes connected to a tank of water above and below, between which the boiler's exhaust gases passed.

Learn More

School of Engineering < The University of Kansas

Enhanced Oil Recovery processes such as primary, secondary, and tertiary oil recovery techniques will be presented. This includes miscible/immiscible displacement, chemical processes such as polymerflood, surfactant and micellar flood, and thermal recovery techniques such as steam flooding, in-situ combustion, and other EOR techniques.

Learn More

Applied Thermodynamics, 3rd Edition | Boiler | Pressure

Piston shall be supported by the gas inside, therefore, let mass of piston be m kg. Boiler: Boiler is the engineering device used for steam generation at consta nt pressure. Heat is supplied externally to the boiler for steam generation depending upon state of s team desired. Steam in Condensate out Fluid out Cold fluid in 1 2 Fig. 3.22

Learn More

Engine Thermal Efficiency - an overview | ScienceDirect Topics

The evaporator (boiler) is a high-efficiency heat exchanger to absorb heat from the exhaust gas or EGR gas and transfer the exhaust energy to the working fluid. The expander may be able to handle two-phase flows and produces mechanical or electrical power. The expander can be an axial turbine, a piston expander, a screw or scroll expander.

Learn More

Evaporator Coils, Manufactured Housing, HVAC Equipment

Evaporator Coils, Manufactured Housing, HVAC Equipment, including Manufactured Housing Coil Revolv Sweat Connection, Manufactured Housing Coil Flex,..

Learn More